Laminate floor classification

Aug 17, 2022

1. There are thin and thick (more than 8 mm and about 12 mm) in thickness.

In terms of environmental protection, thin ones are better than thick ones. Because it is thin, less glue is used per unit area. The thick one is not as dense as the thin one. The impact resistance is poor, but the foot feel is slightly better. But in fact, the difference between the two is not big.

2. There are standard, wide plate and narrow plate in terms of specifications

Standard, width - generally 191-195 mm. About 1200 and 1300 in length. The length of the wide plate is more than 1200 mm and the width is about 295 mm. The length of the narrow plate is 900-1000 mm, and the width is basically about 100 mm. The specifications of the approximate solid wood floor are mostly called the imitation solid wood floor.

The standard specifications are adopted by most members of the European floor Producers Association. The wide plate specification was invented by the laminate flooring and I enterprises in China to meet the consumer demand. Its advantage is that it looks generous and there are relatively few gaps in the floor. Most of them are thickened, i.e. about 12 mm. Generally, the decorative paper on the surface is made in China, with a variety of patterns and colors, which is flexible. The disadvantage is that the color difference is relatively large. Narrow plate specification is also a feature of China.

3. From the surface coating, there are aluminum oxide, and piano paint.

The surface of the standard laminate floor should contain aluminum oxide wear-resistant paper. It has 46g, 38g, 33g, and even lower. It is directly sprayed with aluminum oxide on decorative paper. According to the national regulations, the surface wear-resistant revolution of the laminate floor used indoors should be more than 6000 revolutions. Only the floor with 46 grams of wear-resistant paper can meet the requirements. The abrasion resistance of 38 g abrasion resistant paper can reach 4000-5000 revolutions, and 33 G is lower. It's good to spray aluminum oxide directly, and it can reach 2000-3000 revolutions. The material cost is relatively low if the number of wear-resistant revolutions is low; Because of its low wear resistance, the cutting tool cost is also low. On the contrary, if the number of wear-resistant revolutions is high, the cost is much higher.


You Might Also Like