Analysis of the whole process before and after installation of plastic wood floor

Before installing the plastic wood floor: install the plastic wood floor professionally from the technical point of view. Before the installation, ensure that the plastic wood floor is dry and manic enough, clean and flat, and excellent conditions to ensure the final actual effect, and also reflect more smooth installation work without endangering intermediate applications; The installation of small tools shall be prepared in advance. The electric hand drill and carpenter's small tools are often used. The rubber gloves for labor protection articles are prepared in advance. There are also more stainless steel plate screws. The installation of plastic wood floors such as electric hand drill is an indispensable small tool.

Due to the relatively large ductility of the raw materials of the plastic wood floor, the middle wood floor and the main development and fixation keel are fixed. It is better to use the hand drill to drill holes, and then use the screws of the development and stainless steel plate to fix the two. The key is to be stronger and prevent the damage caused by the loss of the plastic wood floor.

The whole process of installing wood plastic floor: the first main plastic wood floor keel is fixed on the clean concrete floor of the horizontal main keel to ensure this symmetry. Each main keel with an interval of at least 30 cm is drilled by hand electric drill. The size of the drilled hole is not less than the straight diameter of the screw. After the screw is drilled to the main keel, the concrete is fixed on the ground with stainless steel screws. The screws must be completely tightened, For example, the main keel of the wood plastic floor should not be exposed, which will cause uneven wood plastic floor.

The design of upper and lower male and female grooves of all wood floors is to fix the first wood floor before installation. The two sides of the first wood floor are sawed off, and then the surface holes are drilled with a hand drill. The application of stainless steel screws will fix the plastic wood floor on the main keel; For the installation on the second floor, the positive and negative cards will be mainly fixed immediately. The punching surface layer is fixed, and the installers can operate independently according to the interval between the screws. However, the reliability may be ensured. After the installation of the plastic wood floor, the positive and negative cards are fixed with each screw.